Bloomfield 8752 Spécifications télécharger pdf (Page 7)

INSTALLATION (continued)

NOTE: This equipment must be

installed to comply with

applicable federal, state and

local plumbing codes and

ordinances.

WARNING:

SHOCK HAZARD

Brewer must be properly

grounded to prevent possible

shock hazard. DO NOT

assume a plumbing line will

provide such a ground.

Electrical shock will cause death

or serious injury.

IMPORTANT:

Supply power must match

nameplate for voltage and

phase. Connecting to the

wrong voltage will damage the

brewer or result in decreased

performance. Such damage is

not covered by warranty.

IMPORTANT:

Do not connect brewer to

electrical power until you are

ready to fill the tank. See

instructions on page 6.

A water shut-off valve should be installed on the incoming water

line in a convenient location (Use a low restriction type valve,

such as a 1/4-turn ball valve, to avoid loss of water flow thru the

valve.

NSF requires that the brewer be able to be moved for cleaning

underneath. A flex line or loops of copper tubing will satisfy this

requirement. See Figure 2 below.

In some areas, local codes require a backflow preventer (check

valve) to be installed on the inlet water line. If a backflow

preventer is used, you must install a water hammer arrester in

the incoming line, between the backflow preventer and the

brewer inlet, as far away from the brewer as space will allow.

This will relieve the excessive back pressures that can cause

faucet leaks and solenoid malfunctions.

ELECTRICIAN’S INSTALLATION INSTRUCTIONS

REFER TO ELECTRICAL SPECIFICATIONS - Page 1

Check the nameplate to determine correct electrical service

required for this installation.

IMPORTANT: Before connecting to electricity, make sure the

brewer is connected to the water supply.

IMPORTANT:

For power supply connections use COPPER WIRE only. Wiring

must be suitable for at least 75ºC. This brewer requires a

dedicated electric circuit.

Models 8752 must be wired by an electrician, and require a

115/230V 20A circuit (50/60 Hz, 2 hot legs / 1 neutral leg, plus

ground). Remove rear panel to gain access to terminal block.

Green terminal must be connected to a suitable building ground.

Circuit must be capable of 4000 Watts. See figure 3 at right.

IMPORTANT: Wiring must be installed in approved solid or

flexible conduit, and must be secured to the brewer with a strain

relief (to be provided by the installer).

Fig. 2 Water Supply Installation

Fig. 3 Electrical Installation

605 70988 Owners Manual Integrity 5W Decanter Brewer

1 2 3 4 5 6 7 8 9 10 11 12 ... 25 26

Commentaires sur ces manuels

Pas de commentaire

Bloomfield 8752 Spécifications Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Cafetières Bloomfield 8752